Texas Cold Snaps Burst Pipes: How to Protect Yours

Every deep freeze teaches homeowners the same lesson all over again: our homes are built for normal winters, not for a week of single-digit cold. Plumbing that would survive a Minnesota winter is protected there by design — here, lines run through attics, exterior walls, and crawlspaces with little insulation, because hard freezes are supposed to be rare. When an arctic outbreak does arrive, thousands of pipes split on the same night.

Why Texas pipes burst so easily

It's not the cold alone — it's exposure plus surprise. Lines in uninsulated attics and exterior walls see temperatures close to outdoor air. Water freezes, expands, and splits the pipe. The cruel part: the leak usually announces itself at the thaw, when pressure returns and the split opens into a flood while everyone's at work assessing the storm.

The five moves before a freeze

Disconnect and drain every garden hose, and cover outdoor spigots. Open cabinet doors under sinks on exterior walls so warm air reaches the pipes. Let faucets farthest from the water heater drip overnight — moving water resists freezing and relieves pressure. Know where your main shut-off is and make sure it turns. And keep the heat on, even if you leave town — 55 degrees minimum.

What to watch during and after

If a faucet slows to a trickle during a hard freeze, a line is freezing upstream — open the tap and warm that area immediately. After the thaw, walk the house before turning anything back to full pressure: look for damp drywall, listen for hissing in walls, and check the attic and crawlspace with a flashlight. A split found in the first hour is a repair; found in the second day, it's a plumbing.

If a pipe does burst

Shut the main off first — every minute matters. Kill power to any wet area if you can reach the panel safely. Then call. A local plumber can find the split, repair the line, and check the runs that nearly failed, because the pipe that bursts is rarely the only one that froze.